![]() Turn the power on and make sure everything works properly before installing the cover plates. Nilight Waterproof Rocker Switch Toggle ON Off ON Switch DPDT 7Pin 12V 24V Switch Jumper Wires Winch Pump Switch for Cars Trucks Caravans Boats RV SUV ATV UTV,2 Years Warranty. Run a strip of electrical tape around the edges of both the outlet and the switch to insulate their wire connections too.Ĭarefully press the outlet and switch into their respective boxes. Step 12: Wrap each wire nut firmly with electrical tape. Step 11: Attach the black wire running from the switch to one of the gold screws on the outlet. Step 10: Twist the disconnected hot wire from the outlet and the red wire running from the switch into a wire nut. Twist the other end into a wire nut with the white wire running from the switch and the disconnected neutral wire. Disconnect the wires from the existing switch with a screwdriver. ![]() Measure the height, width, and depth of the electrical box in place to determine if your new light switch will fit. Step 9: Attach the other jumper wire to one of the silver screws on the outlet. Connect one end of the wire in the NO point of the relay module and the other end in the COM point of the relay point. Unscrew the top and bottom of the switch in place, and remove it gently from the box. Twist the other end of the jumper wire into a wire nut with the green wire running from the switch and the disconnected ground wire. Attach one jumper wire to the outlet’s grounding screw. Toggle Switch Short Ball SPST On-Off Wire Leads Great for power tool and motor control switch applications Rugged long-wearing solid brass/nickel-plated. Blue Sea Systems 9003E E-Series On Off Battery Switch is in stock ready to ship. Step 7: Shut the power supply back off and disconnect the green ground wire, the black hot wire and the white neutral wire from the outlet. Step 6: Turn the power supply back on and use the voltage sensor to identify the hot and neutral wires connected to the outlet. Step 5: Use a voltage sensor to confirm that there is no power running to the outlet. Step 4: Remove the outlet cover plate, unscrew the outlet mounting screws and pull the outlet out from inside the electrical box. Step 3: Use the circuit breaker or fuse in the electrical panel to shut off the power supply to the outlet the switch will be connected to. Use a wire nut to cap off the unattached white wire end. With the switch on, you are shorting out all four black and red wires to each other. ![]() Connect the black wire to the gold screw and the red wire to the silver screw. The way a switch works is it either shorts out its two terminals, or it does not. Step 2: In the switch box, connect the green wire to the grounding screw on the switch.
0 Comments
Leave a Reply. |